Nizpro ECU Flash - VF150 SHO 2.8L L4 231 FSR

Nizpro Marine 231 FSR Performance Re-Power is for 2013 and newer models only. It optimizes your engine’s performance while reducing fuel consumption and still maintaining the legendary Yamaha reliability. The stock VF150 SHO engines have 164.5 hp so you will see an increase of approximately 67 hp.

Not worried about the cost of fuel? Then enjoy the extended range with the extra fuel still in the tank!

NOTICE: You are not purchasing an ECU but an ECU reprogramming service by sending your ECU in to us. This will not change your engine hours or override any mechanical problems that are hindering your engines performance. Your ECU is located on the front of the engine and it is recommended that the battery be disconnected or power kill switch have power turned off prior to removal to prevent accidental electrical interference that can put the ECU into a factory lock down and not allow Nizpro Tuning to be performed.

To get the process started just add the correct Tune option to your cart and check out and then include your information in the box with your ECU and ship to using the address below. 
Tuning is generally a 24hr turnaround when we have your engine model and ECU number ahead of time.
Return Express shipping with $1,500 insurance and signature confirmation is included at checkout but it is up to you to properly package, ship and insure your ECU to us.

When shipping your ECU please include the boat year and application in "message from customer" section and ship to:
Three Rivers Tackle
4345 Twin Lake Ct
West Richland, WA. 99353

Attention: Please Read prior to purchasing the Nizpro Powering Service and call if you have questions: A Nizpro Tune cannot compensate for a poorly running engine if there are other factors causing a loss of performance that need addressed first. Results can vary for every application due to differences in vessel weights, hull design, altitude, engine height, prop pitch and efficiency. If your boat is not reaching its full range of rpm at WOT beforehand of 6,000 - 6,200 rpms (This varies with load, temperature and altitude) before a Flash then you may have need of getting your boat dialed in after the Tune with the proper engine height adjustment and by using the correct prop with necessary cupping and pitch in order to achieve the most efficiency from it. Depending on the HP you started with you may need to make bigger pitch changes to your prop to get closer to your target rev limit.  

It is advised that you do pre-flash testing so you can determine the amount of change in fuel economy and speed that have been been achieved from your Nizpro Tune.
Check fuel numbers (GPH) and speed at 3,000/4,000/5,000 and WOT before and after the Tune.